Halloween Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: buysanta

Exact2Pass Menu

Login / Register

Question # 4

Refer to the exhibit.

A network administrator sets up 802.1X authentication to a RADIUS server on an AOS-Switch. The RADIUS server and user devices are both set up to use REAP MSCHAPv2. The administrator tests the authentication and sees the output shown in the exhibit. Which issue could cause this output?

A.

The RADIUS shared secret does not match on the switch and the server.

B.

The administrator entered the wrong password for the test account.

C.

The switch does not have a certificate tor port-access installed on the switch.

D.

The switch port is set for user mode 801. IX. but the RADIUS server is set for port mode.

Full Access
Question # 5

What is a primary use case for RPVST+ on AOS-Switches?

A.

more granular load balancing than MSTP when access switches connect to two core switches

B.

enhanced loop protection in an MSTP network

C.

integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol

D.

seamless integration with RSTP

Full Access
Question # 6

Why is a terminate session enforcement profile used during posture checks with 802.1 x authentication?

A.

To send a RADIUS CoA message from the ClearPass server to the client

B.

To disconnect the user for 30 seconds when they are in an unhealthy posture state

C.

To blacklist the user when they are in an unhealthy posture state

D.

To force the user to re-authenticate and run through the service flow again

E.

To remediate the client applications and firewall do that updates can be installed

Full Access
Question # 7

Which statement is true about the databases in ClearPass?

A.

Entries in the guest user database do not expire.

B.

A Static host list can only contain a list of IP addresses.

C.

Entries in the guest user database can be deleted.

D.

Entries in the local user database cannot be modified.

E.

The endpoints database can only be populated by manually adding MAC addresses to the table.

Full Access
Question # 8

Which ArubaOS CLl command can an administrator execute to determine if AP load balancing is enabled in a cluster?

A.

show switches

B.

show lc-cluster group-membership

C.

show aaa cluster essid

D.

show ap active

Full Access
Question # 9

Refer to the exhibit.

A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?

A.

The standby uses its own port in the link aggregation to forward the fabric.

B.

The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.

C.

The standby uses the typical load sharing algorithm, and it might select either its port or the commander’s port.

D.

The standby selects the port on the designated forwarder for the aggregation.

Full Access