Weekend Special Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: buysanta

Exact2Pass Menu

Login / Register

Question # 4

Which functionalities of ClearPass can be added in a wired network that implements dynamic segmentation? (Select two.)

A.

Profiling

B.

Fingerprinting

C.

Downloadable user Roles

D.

Multi Factor Authentication

E.

Dynamic VLANs

Full Access
Question # 5

Refer to the exhibit.

A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?

A.

Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.

B.

Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports

C.

Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.

D.

Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.

Full Access
Question # 6

Company A and Company B are merging their BGP routed networks The companies have overlapping IP ranges and security concerns during the migration phase. Which Aruba CX 8325 functionality would help the merging of networks in a secure way?

A.

Use of ACL's to separate the company networks at the VLAN level

B.

Use of Aruba Gateway appliance to control the routes between merged networks

C.

Use of vsf capable switch to integrate the routing

D.

Use of virtual route forwarding and BGP route leaking

Full Access
Question # 7

Refer to the following configuration:

How do you configure QoS policies for user traffic in conjunction with user roles in all wired access switches? (Select two)

A.

Use NetEdit to replicate the configuration of QoS policies to all wired switches

B.

in a RADIUS server with Aruba Vendor Specific Attribute (VSA) dictionary, you can add QoS policies for user roles.

C.

With ClearPass and downloadable user roles, you can add QoS policies for user roles

D.

QoS policies should be configured by the Mobility Controller when you need to set to all wired access switches

Full Access
Question # 8

When planning a new wired network solution for an organization, mere are technical goals that must be achieved to support the organization objectives and their applications and services.

Which options are valid technical goals? (Select two.)

A.

Reduce the cost of wiring.

B.

Transform the process of acquisition of a new network solution from a CAPEX to an OPEX model

C.

improve the network throughput

D.

Replace hardware that is reaching end of support with a technology refresh.

E.

Accelerate the ordering process of new network hardware.

Full Access
Question # 9

(Scenarios may contain multiple errors which may or may not Impact the solution)

Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration, it is required to implement Multi-Chassis Link Aggregation for each pair of switches

The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows:

There is an error message staling "incompatible interface." Which interfaces are the cause of the error? (Select two.)

A.

1/1/12 10GBaseT SFP*+ 30m Cat6A Transceiver

B.

1/1/49 40G QSFP+ 15m Active Optical Cable

C.

1/1/13 10GBaseT SFP+ 30m Cat6A Transceiver

D.

1/1/48 iGBaseT 100m Cat5e Transceiver

E.

1/1/50 40G QSFP+ 15m Active Optical Cable

Full Access